Double Joint Arrangement
- Designed with two Lovejoy D Type universal joints and a center connecting shaft
- DD and DDX Type universal joints are tailored to your specific application requirements
- This configuration compensates for both parallel misalignment and shaft separation
- Round, hex, splined, or keyway bores are supplied per your requirements
- Boot retaining grooves are standard. (Boots are available for purchase separately.)
- Lubrication is required for optimal wear – boots and lubricant extend universal joint life
|Description||DD4 UJNT SOLID|
|Type||Universal Joints - DD Type|
|Std Bore||0.380 in|
|Set Screw Size||No Setscrew|
|Outside Diameter||0.750 in|
|Overall Length||5.380 in|
|Bore Depth (Dimension C)||0.880 in|
|Max. Bore - No Keyway (Dim. ID1 & ID2)||0.620 in15.00 mm|
|Main Pin Height (Dimension E)||1.34 in|
|Dimension F (Standard)||2.680 in68.07 mm|
|Dimension F (Minimum)||1.810 in45.97 mm|
|Cubic inches||3.02625 in³|
|Operating Temperature Range||-20 to 212 ºF|
|Static Breaking Torque||768.00 in·lb|
|Max. Speed||1750.00 rpm|
|Static Breaking Torque||768.00 in-lb|
|Max. Angle Offset||25.00 º|
- Static Breaking Torque is not recommended operating torque.
- Square and hex bore measured across the flats.
- Bores other than shown are available at additional charge.
- Shorter centers upon request.
Item must be unused.
Item must be in it's original package.
Restocking, shipping and handling fees may applied to any return with this manufacturer.
For more information please consult https://www.mrosupply.com/page/returnwarranty-policy/