Image for Illustration purposes only. Actual product may vary
|Description||SE15 RUNRIGHT TENSIONER, STANDARD|
|Element Material||Natural Rubber|
|Mounting Bolt Size||M8 x 25|
|Outside Diameter (Dim D)||1.77 in|
|Overall Length (Dim E)||2.52 in45 mm|
|Idler Bolt Size||1/2 - 13 x 2|
|Dimension L||4.43 in112.5 mm|
|Dimension J-1||3.94 in100 mm|
|Dimension J-2||3.15 in80 mm|
|Dimension L1||25 mm|
|Dimension G||0.2 in5 mm|
|Dimension O||0.31 in8 mm|
|Dimension P||0.33 in8.5 mm|
|Dimension K||0.98 in25 mm|
|Cubic inches||19.75957 in³|
|Normal Temperature Range||-40 to 180 ºF-40 to 80 ºC|
|Mounting Bolt Torque||25 N·m221 in·lb|
|Force at 20° Angle of Pretension (Normal Force Level) (Dimension F)||14.6 lb65 N|
|Distance at 20° Angle of Pretension (Normal Force Level) (Dimension S)||1.3 in34 mm|
- The recommended angle of pretension is 20°. This provides the tensioner a maximum capability to absorb vibrations and shock loads, while also maintaining a range of motion to address the system’s belt or chain stretch.
- Mounting accessories into the “Hard” Position results in approximately 25% higher tensioning force over the “normal” position.
- Inch (imperial) standard tensioner units all come with both the mounting screw and a zinc-plated idler bolt with nuts.
Item must be unused.
Item must be in it's original package.
Restocking, shipping and handling fees may applied to any return with this manufacturer.
For more information please consult https://www.mrosupply.com/page/returnwarranty-policy/