We never sell your data to third parties
SKF TMCD 5P bearing installation and removal tool for proper mounting and dismounting of bearings. Reduces risk of damage during maintenance. Suitable for industrial maintenance and repair operations.
MODEL TMCD 5P
$1,094.94 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Pack Height
81 mm
Pack Length
107 mm
Pack Width
102 mm
Vertical dial gauge for Hydraulic nuts
The SKF dial indicators are used in conjunction with the SKF Drive-up Method, to measure the axial travel of the piston in an hydraulic nut E-design. This travel distance is also known as the drive-up distance and important for correct mounting bearings and maximising their life.
- Accurately measure the drive-up distance during the drive-up process
- Ensure proper fitting in the outside ring of the hydraulic nut.
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
| Brand | MROSupply Fasteners |
| Model | FSTPCK-V71038 |
| Brand | Remco Products |
| Model | 62507-BS |
| Brand | Remco Products |
| Model | 62507-BR |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF