We never sell your data to third parties
Image for Illustration purposes only. Actual product may vary
The SKF HMV 120/233983 is a hydraulic nut used for mounting and dismounting bearings with tapered bores. It generates precise axial force via hydraulic pressure, enabling safe and controlled installation or removal of large bearings. This tool is essential for maintenance on heavy industrial equipment such as gearboxes, mills, and presses.
MODEL HMV 120/233983
$163.41 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Pack Height
83 mm
Pack Length
104 mm
Pack Width
102 mm
Spare O-ring set for Hydraulic nut (all versions)
The SKF HMV 120/233983 spare part is an O-ring replacement set, consisting of one O-ring to seal the inner surface of the piston and one O-ring to seal the outer surface of the piston of the HMV nut. Suitable for hydraulic nut size 120: HMV 120E and HMVC 120E.
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF