We never sell your data to third parties
Timken T-3074-C is a pillow block bearing accessory. This component is used in the assembly or maintenance of Timken mounted bearing units.
MODEL T-3074-C
$3,539.53 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable:No
Appropriate hydraulic nut
HMV 26 C:23 mm D:165 mm G:M130 x 2 Locknut:KM26 Lockwasher and lockplates:MB26 Thread G:M130 x 2 d1:4.4375 in
For bearings
230/530K to 230/750K, 23168K to 23196K, 23260K to 23276K, 239/750K to 239/1120K
For Bearings
230/530K to 230/750K, 23168K to 23196K, 23260K to 23276K, 239/750K to 239/1120K
Size
7
- Tapered-bore, antifriction bearings are mounted either on adapter sleeves or on tapered shaft seats.
- In cases where tapered bore bearings are mounted directly on the shaft, the shaft must conform to the tapered bore of the bearing to assure proper fit. If a proper fit is not achieved, the results could be:
- Turning of the bearing inner race on the shaft.
- Uneven loading of the bearing.
- Severe inner race hoop stress.
- Insufficient support (back-up) of the inner race on the shaft.
- All of these conditions could lead to premature bearing damage. Therefore, the manufacture, maintenance and measurement of accurate shaft tapers is important.
- There are two accepted ways of measuring tapered shafts: ring gages and sine bar gages.
- Precision measurement of tapered shafts is difficult with ring gages and may be impossible in the case of large shafts where gages are large, cumbersome and heavy.
- Sine bar gages provide an accurate and easy method of measurement.
- Lightweight and easy to handle and learn, sine bar gages achieve precise gagging of the shaft size and taper.
- A complete set for measurement of 1:12 shaft tapers consists of 3 in, 4 in, 5 1/2 in, 7 in, 10 in and 14 in sine bar gages, sine bar saddle no. T-5491-C, web clamp no. T-5489-A and a wooden box no. T-5224-C. A complete set for 1:30 shaft tapers consists of 4 in, 6 in, 8 in and 12 in sine bar gages.
- Sine bars can be purchased individually, or in any combination of sizes to meet your individual needs.
- All sine bars require a sine bar saddle and web clamp. A wooden box is optional.
SKU: 5066946
Best company to buy from
I always buy from MRO is a very reliable company to work with
Read moreHow do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
SKU: 5066946
Best company to buy from
I always buy from MRO is a very reliable company to work with
Read more