We never sell your data to third parties
FAG 6314-2Z deep groove ball bearing with 70mm bore and 150mm OD. Double shielded (2Z) for grease retention and contamination protection. Suitable for high-speed applications requiring low friction and quiet operation. Precision German engineering from Schaeffler.
MODEL 6314-2Z
$354.52 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Bore Type
Straight
Cage Material
Steel
Closure Type
Double Shielded
Fillet Radius
2.1 mm
Finish Coating
Uncoated
I.D.
70 mm
Internal Clearance
C0
Max Rpm
5200 rpm
O.D.
150 mm
Operating Temperature Range
-30 to +120°C
Overall Width
35 mm
Precision Rating
Not Rated
Product Type
Radial & Deep Groove Ball Bearings
Radial Dynamic Load Capacity
111000 N
Radial Static Load Capacity
68000 N
Row Type Fill Slot
Single Row Non-Fill Slot
Series
63
Snap Ring Included
Without Snap Ring
Standards Met
DIN 625-1
Deep groove ball bearing 63..-2Z, single row, shields, steel sheet metal cage
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
What is the difference between deep groove and angular contact ball bearings?
Deep groove ball bearings are the most common type. They’re designed to handle mainly radial loads, but they can also take some axial load in both directions. They’re simple, versatile, and used in everything from motors to conveyors. Angular contact ball bearings are built for combined loads, especially where there’s significant axial force in one direction. They’re often used in pairs and are common in higher precision or higher load applications like pumps and gearboxes. If your load is mostly radial, go deep groove. If axial load matters more, angular contact is usually the better choice.