We never sell your data to third parties
FAG 6205-C-2HRS-L038-C3 is a Generation C deep groove ball bearing with a 25mm bore. It features double sealed contact seals (2HRS), C3 internal clearance, and long-life grease lubrication. This bearing is designed for high-speed applications requiring low friction and extended service life.
MODEL 6205-C-2HRS-L038-C3
$29.23 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable:No
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
What are the dimensions and typical uses of a 6200 series ball bearing?
A standard 6200 ball bearing has: • 10 mm bore • 30 mm outer diameter • 9 mm width The 6200 series sits within the deep groove ball bearing family and is designed for light to moderate loads at relatively high speeds. You’ll typically find them in electric motors, small gearboxes, pumps, and general industrial equipment. They’re popular because they’re compact, widely available, and cost effective. Different variants exist such as sealed, shielded, or high clearance versions, depending on the application.
What is the difference between deep groove and angular contact ball bearings?
Deep groove ball bearings are the most common type. They’re designed to handle mainly radial loads, but they can also take some axial load in both directions. They’re simple, versatile, and used in everything from motors to conveyors. Angular contact ball bearings are built for combined loads, especially where there’s significant axial force in one direction. They’re often used in pairs and are common in higher precision or higher load applications like pumps and gearboxes. If your load is mostly radial, go deep groove. If axial load matters more, angular contact is usually the better choice.
