We never sell your data to third parties
Koyo 6204 is a 62 series single-row deep groove ball bearing with a 20 mm bore, 47 mm OD, and 14 mm width. Open type design for general industrial rotating equipment such as electric motors, pumps, and fans. 6200 Open Bearing
6204 and 6204C3
MODEL 6204
Koyo Bearing
$10.09
SKF Bearing
$14.34
Timken
$13.69
NTN Bearing
$13.64
Call to confirm
NSK Bearings
$12.84
In stock
Nachi Bearing
$6.27
In stock
FAG Bearing
$12.84
OBSOLETE
Please call 888-671-2883 for Replacement info
Typically Ships in: 1 day
Returnable:No
Bore
14
I.D.
20 mm
O.D.
47 mm
| Bearing No. | 6204 | |
| Boundary dimensions(mm) | d | 20 |
| D | 47 | |
| B | 14 | |
| r(min) | 1 | |
| Basic load ratings(kN) | Cr | 16.0 |
| C0r | 6.65 | |
| Fatigue load limit(kN) | Cu | 0.510 |
| factor | f0 | 13.2 |
| Limiting speeds(min-1) | Grease lub. | 15000 |
| Oil lub. | 17000 | |
| Mounting dimensions(mm) | da(min) | 25 |
| Da(max) | 42 | |
| ra(max) | 1 | |
| (Refer.)Mass(kg) | 0.106 |
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
What is the difference between deep groove and angular contact ball bearings?
Deep groove ball bearings are the most common type. They’re designed to handle mainly radial loads, but they can also take some axial load in both directions. They’re simple, versatile, and used in everything from motors to conveyors. Angular contact ball bearings are built for combined loads, especially where there’s significant axial force in one direction. They’re often used in pairs and are common in higher precision or higher load applications like pumps and gearboxes. If your load is mostly radial, go deep groove. If axial load matters more, angular contact is usually the better choice.