Saginaw Control SCE-48XEL3712LP12 XEL LP Enclosure (Nema 12)

Application

Designed to house electrical and electronic controls, instruments and components. Provides protection from dust, oil and water. Designed to house most standard type disconnects. For outdoor application a drip shield is recommended.

Construction

• 0.075” carbon steel.
• Seams continuously welded and ground smooth.
• Flange trough collar around all sides of door opening.
• Oil-resistant gasket.
• Collar studs provided for mounting optional panels.
• Disconnect cutout provided on flange.
• Concealed hinge.
• Doors are interchangeable and easily removed by pulling hinge pins.
• 3-point latching mechanism.
• Latches are opened or closed with a screwdriver (optional tamper-resistant inserts are available).
• Mounting holes on back of enclosure.
• Mounting hardware, sealing washer and hole plug included.
• Ground studs on door and body.
• Black zinc die cast coinproof/padlocking handle.

Finish

ANSI-61 gray powder coating inside and out. Optional sub-panels are powder coated white.

Industry Standards - (IS3)

NEMA Type 3R, 12 and Type 13UL Listed Type 3R and 12CSA Type 3R and 12IEC IEC 60529 IP IP 55

Notes

Disconnect switch (or circuit breaker) and operating mechanism are not furnished with this enclosure. Special Instructions apply for IS3, IS4 and IS6 to maintain the environmental rating of Type 3R for these parts. Instructions are located on the enclosure door. Drip shield is required on IS3, drip shield is recommended on IS4 and IS6. Drain holes are required on all.