Saginaw Control SCE-72XEL7318LP 2DR XEL Enclosure

Application

Designed to house electrical equipment and provide protection from dirt, dust, oil and water and to house most standard type disconnects.

Construction

• 0.104” carbon steel.
• Seams continuously welded and ground smooth.
• Flange trough collar around all sides of door opening.
• Oil-resistant gasket.
• Concealed hinge.
• Removable and interchangeable doors.
• 3-point latching mechanism.
• Removable print pocket.
• Lifting eyes for easy handling.
• Ground studs on door and body.
• Collar studs provided for mounting optional panels.
• 15” removable floor stand.
• Removable center post.
• Mechanical interlock.
• No door stiffeners required.
• Black zinc die cast coinproof/padlocking handle on main door of disconnect enclosures. Black zinc die cast padlocking handle on all other doors.

Finish

ANSI-61 gray powder coating inside and out. Optional sub-panels are powder coated white.

Industry Standards - (IS4)

NEMA Type 3R, 4, 12 and Type 13UL Listed Type 3R, 4 and 12CSA Type 3R, 4 and 12IEC IEC 60529 IP IP 66

Notes

Disconnect switch (or circuit breaker and operating mechanism) are not furnished with this enclosure. Special Instructions apply for IS3, IS4 and IS6 to maintain the environmental rating of Type 3R for these parts. Instructions are located on the enclosure door. Drip shield is required on IS3, drip shield is recommended on IS4 and IS6. Drain holes are required on all.