Saginaw Control SCE-90XM4EW18 4DR XM Enclosure

Application

Designed to house electrical equipment and provide protection from dirt, dust, oil and water and to house most standard type disconnects.

Construction

• 0.125” carbon steel.
• Seams continuously welded and ground smooth.
• Flange trough collar around all sides of door opening.
• Body stiffeners in large enclosures for extra rigidity.
• Heavy duty lifting eyes anchor into reinforced top.
• Removable centerposts permit easy panel installation.
• Concealed hinge
• Black zinc die cast coinproof/padlocking handle on main door with black zinc die cast padlocking handle on slave doors.
• 3-point latching mechanism.
• Ends of latch rods have ramp shoes for easier door closing.
• Panel supports.
• Large removable print pockets.
• Oil-resistant gasket.
• Removable panels mount to collar studs.
• Master door is far right-hand door on all enclosures.
• Defeater on master door requires a screwdriver to open.
• Mechanical interlock activated by master door prevents slave doors from being opened first. Doors can be closed in any order.
• Ground stud on door and body.
• Provisions for light kit.

Finish

ANSI-61 gray powder coating inside and out. Subpanels are powder coated white.

Industry Standards - (IS3)

NEMA Type 3R, 12 and Type 13UL Listed Type 3R and 12CSA Type 3R and 12IEC IEC 60529 IP IP 55

Notes

Disconnect switch (or circuit breaker) and operating mechanism are not furnished with enclosure. Special Instructions apply for IS3, IS4 and IS6 to maintain the environmental rating of Type 3R for these parts. Instructions are located on the enclosure door. Drip shield is required on IS3, drip shield is recommended on IS4 and IS6. Drain holes are required on all.