Starrett 684-4Z internal chamfer gage measures 1 to 2 inch diameters with 0.001 inch graduations. The hardened tool steel construction and white dial provide durability and clear readability. This 3-blade plunger gage is designed for 90-127 degree chamfer angles.

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the gage may be adjusted to read the proper number. 1-2" Range In case of wear, the gage may be adjusted to read the proper number.

Features

• When the three blade plunger is pressed against a flat surface, the gage should read the set number stamped on the back of the indicator
• No setting master is necessary
• Internal gages will measure the largest diameter of any chamfer that has an included angle within the range of angles printed on the dial face
• Gages are also available with electronic indicators on request
• Deluxe padded case
• All ground surfaces are of hardened tool steel
• Indicators are AGD design
• Gages directly measure the diameter of chamfered holes
• For 90 - 127 deg Dial reading