Kipp K0345.2105AL indexing plunger, size 1, with 3/8-24 internal thread and 5mm pin diameter. Steel hardened body, form K with threaded pin and locknut. Spring force initial 5 N, final 12 N, travel 5 mm. Suitable for fixturing and workholding applications.

Material:

Steel version
Indexing pin hardened:
grade 5.8.

Stainless steel version
Indexing pin hardened:
Threaded body 1.4305 (AISI 303 equivalent).
Indexing pin 1.4034(AISI 420 equivalent).

Indexing pin not hardened:
Threaded body 1.4305 (AISI 303 equivalent).
Indexing pin 1.4305 (AISI 303 equivalent).

Version:

Steel version:
Indexing pin hardened, ground, black oxidized.

Stainless steel version:
Indexing pin hardened, ground and bright.
Indexing pin not hardened, ground and bright.

Note:

Indexing plungers are used to prevent any change in locking position due to lateral forces. A new locking position can only be set after the pin has been disengaged.
Special grips can be fitted on the projecting threaded pin. This pin is also suitable for automatic actuation by e.g. program controlled pneumatic cylinder or by remote control using bowden cables.
A washer is available to aid screwing in the indexing plungers. The washer is placed on the threaded body so that the carrier pins engage in the slot.

On request:

Special versions.

Accessory:

Spacer rings K0665