We never sell your data to third parties
SKF / CR Seals (formerly CR Seals) 99230 is a Speedi-Sleeve shaft repair sleeve designed to restore worn shaft surfaces. This thin-walled stainless steel sleeve provides a new sealing surface without shaft removal or machining. Installs quickly over the worn area to extend equipment life. Suitable for use with any radial shaft seal.
MODEL 99230
Contact supplier for technical support on: 267-436-6000
$52.40 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
SSLV
Max shaft diameter
56.72 mm, 2.233 in
Min shaft diameter
56.57 mm, 2.227 in
Removable flange outside diameter
64.29 mm, 2.531 in
Seal seat width
19.84 mm, 0.781 in
Shaft diameter
56.64 mm, 2.23 in
Shaft diameter, maximum
56.72 mm, 2.233 in
Shaft diameter, minimum
56.57 mm, 2.227 in
Type
Standard
SKF Speedi-Sleeve
SKF Speedi-Sleeve provides an alternative to costly repairs for worn or damaged shafts. This thin-walled sleeve, specially developed by SKF, is simply positioned over the relevant part of the shaft and provides a smooth counterface that is optimized for radial shaft seals. Use of SKF Speedi-Sleeve can prevent the need for costly shaft treatments that may involve machining, hardening, plunge grinding or disassembly. SKF Speedi-Sleeve Gold is an enhanced version of standard SKF Speedi-Sleeve, offering improved resistance to abrasive wear.
- Optimized countersurface
- Cost effective
- Well-proven solution
| Brand | M.K. Morse |
| Model | 102865 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF