We never sell your data to third parties
SKF / CR Seals (formerly CR Seals) 400030 is a small V-ring axial face seal designed for rotating shafts. The flexible rubber construction provides a reliable sealing action against contaminants and lubricants. Suitable for use in electric motors, gearboxes, pumps, and other rotating equipment. SKF / CR Seals V-rings prevent lubricant leakage and exclude contaminants from precision bearing assemblies.
MODEL 400030
Contact supplier for technical support on: 267-436-6000
$3.22 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR1
Max shaft diameter
3.5 mm, 0.138 in
Min shaft diameter
2.7 mm, 0.106 in
Seal width
3.0 mm, 0.118 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter, maximum
3.5 mm, 0.138 in
Shaft diameter, minimum
2.7 mm, 0.106 in
V-ring seal, VR1 design, North American standard, interchangeable with VA design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR1 design includes a standard cross section with a straight back side face. Being the most common type of V-rings, VR1 seals are typically used to protect bearing arrangements in gearboxes, electric motors and drives.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
| Brand | FK Bearing |
| Model | COMH20 |
| Brand | System Plast |
| Model | TC-20-12M |
| Brand | MROSupply Fasteners |
| Model | FSTPCK-462046 |
| Brand | Hammond Power Solutions |
| Model | CRX04D8PE |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF