We never sell your data to third parties
SKF / CR Seals 400060 small V-ring axial face seal for shaft diameters from 0.750" to 1.000". NBR sealing lip provides effective contaminant exclusion and lubricant retention in rotating applications. Operating temperature range: -40°F to 250°F. Suitable for electric motors, gearboxes, pumps, and industrial rotating equipment.
MODEL 400060
Contact supplier for technical support on: 267-436-6000
$2.63 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR1
Max shaft diameter
6.5 mm, 0.256 in
Min shaft diameter
5.5 mm, 0.217 in
Seal width
3.7 mm, 0.146 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter, maximum
6.5 mm, 0.256 in
Shaft diameter, minimum
5.5 mm, 0.217 in
V-ring seal, VR1 design, North American standard, interchangeable with VA design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR1 design includes a standard cross section with a straight back side face. Being the most common type of V-rings, VR1 seals are typically used to protect bearing arrangements in gearboxes, electric motors and drives.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
- If not in stock alternatives can be produced by SKF SEAL JET systems
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF