We never sell your data to third parties
SKF / CR Seals 401601 VR1 V-Ring axial face seal for rotating shafts. Provides reliable sealing against contaminants and lubricant leakage in electric motors, gearboxes, and pumps. Flexible elastomer lip mounts directly on the shaft, accommodating axial and radial misalignment. Suitable for industrial rotating machinery.
MODEL 401601
Contact supplier for technical support on: 267-436-6000
$49.29 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR2
Max shaft diameter
165.0 mm, 6.496 in
Min shaft diameter
155.0 mm, 6.102 in
Seal width
20.5 mm, 0.807 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter, maximum
165.0 mm, 6.496 in
Shaft diameter, minimum
155.0 mm, 6.102 in
V-ring seal, VR2 design, North American standard, interchangeable with VS design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR2 design includes a standard low cross section with a tapered back side face and a wide seal body, providing a firm hold on the shaft. VR2 seals are commonly used in agricultural and automotive applications.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
| Brand | NoTrax |
| Model | 130S0046CH |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF