We never sell your data to third parties
SKF / CR Seals 404000 small V-ring axial shaft seal for rotating shafts. Flexible rubber lip seals against a counterface to exclude contaminants and retain lubricant. Suitable for light-duty applications in electric motors, gearboxes, and agricultural equipment.
MODEL 404000
Contact supplier for technical support on: 267-436-6000
$186.67 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR1
Max shaft diameter
430.0 mm, 16.929 in
Min shaft diameter
390.0 mm, 15.354 in
Seal width
25.0 mm, 0.984 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter, maximum
430.0 mm, 16.929 in
Shaft diameter, minimum
390.0 mm, 15.354 in
V-ring seal, VR1 design, North American standard, interchangeable with VA design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR1 design includes a standard cross section with a straight back side face. Being the most common type of V-rings, VR1 seals are typically used to protect bearing arrangements in gearboxes, electric motors and drives.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
SKU: 1898441
Mro supply - seals
I use a lot of the SKF6119 seals for chainsaw repairs and MRO always has the best prices and fast shipping.
Read moreSKU: 1898441
Mro supply - seals
I use a lot of the SKF6119 seals for chainsaw repairs and MRO always has the best prices and fast shipping.
Read moreDisclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF