We never sell your data to third parties
SKF / CR Seals (formerly CR Seals) 110 VS V is a VR1 V-Ring axial face seal designed for 110mm shaft diameter. Constructed with a NBR sealing lip. Operating temperature range: -40°F to 250°F. Suitable for use in electric motors, gearboxes, pumps, and other rotating equipment. SKF / CR Seals shaft seals prevent lubricant leakage and exclude contaminants from precision bearing assemblies.
MODEL 110 VS V
Contact supplier for technical support on: 267-436-6000
$73.80 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Design
VS
Max shaft diameter
115.0 mm, 4.528 in
Min shaft diameter
105.0 mm, 4.134 in
Seal width
18.0 mm, 0.709 in
Sealing lip material
Fluoro rubber (FKM)
Shaft diameter, maximum
115.0 mm, 4.528 in
Shaft diameter, minimum
105.0 mm, 4.134 in
V-ring seal, VS design, global standard, interchangeable with VR2 design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VS design includes a standard low cross section with a tapered back side face and a wide seal body, providing a firm hold on the shaft. VS seals are commonly used in agricultural and automotive applications.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
- If not in stock alternatives can be produced by SKF SEAL JET systems
SKU: 1898441
Mro supply - seals
I use a lot of the SKF6119 seals for chainsaw repairs and MRO always has the best prices and fast shipping.
Read moreSKU: 1898441
Mro supply - seals
I use a lot of the SKF6119 seals for chainsaw repairs and MRO always has the best prices and fast shipping.
Read moreDisclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF