We never sell your data to third parties
SKF / CR Seals 14810 small bore radial shaft oil seal for light-duty sealing applications. Features a spring-loaded sealing lip for consistent radial contact. Suitable for electric motors, gearboxes, pumps, and rotating equipment to prevent lubricant leakage and exclude contaminants.
MODEL 14810
Contact supplier for technical support on: 267-436-6000
$8.04 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Auxiliary lip
No
Design
HM14
Housing bore diameter
47.6 mm, 1.874 in
Maximum operating temperature
100.0 °C, 212.0 °F
Maximum operating temperature (°F)
100.0 °C, 212.0
Minimum operating temperature
-40.0 °C, -40.0 °F
Minimum operating temperature (°F)
-40.0 °C, -40.0
Permissible circumferential speed
6.74 m/s
Rotational speed
3379.0 r/min
Seal width
6.35 mm, 0.25 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter
38.1 mm, 1.5 in
Type of outside diameter
Metal-cased
Unit system
Inch
Radial shaft seal with metal case and single sealing lip, for grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. HM14 seals are designed with a sealant coated metal case. They have a conventional single sealing lip made of elastomer. Typical applications include grease lubricated agriculture machinery.
- Maximise the exclusion of contamination
- Accommodate low speed
- Easy installation
| Brand | MROSupply Fasteners |
| Model | FSTPCK-726418 |
| Brand | Merrick |
| Model | M998201 |
| Brand | PIP |
| Model | 715SNFTK/L |
| Brand | JW Winco |
| Model | 10T2LMB |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF