We never sell your data to third parties
Image for Illustration purposes only. Actual product may vary
SKF SYJ 508 2-bolt cast-iron pillow block bearing unit with bolt-type insert, designed for a 2-1/2 inch shaft. Features set screw locking for secure shaft mounting and is pre-lubricated for maintenance-free operation. Suitable for conveyor systems, fans, and general industrial drives.
MODEL SYJ 508
$58.99 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Centre Distance Between Bolt Holes
136.5 mm
Centre Height (pillow Block)
49.2 mm
Coating
Without
Fastening Bolt Hole Type
Plain
Grease Fitting
With
Housing
Cast iron
Housing Overall Width
49 mm
Housing Type
Pillow block
Number of Bolt Holes for Fasteners
2
Pack Height
98 mm
Pack Length
177 mm
Pack Width
48 mm
Relubrication Hole
With
Spherical Seating Diameter
80 mm
Pillow block housing for insert bearings, cast iron, Japanese standards
Pillow (plummer) block housings are designed to accommodate an insert bearing. The cast iron housings are strong, stiff and cost-effective. They are suitable for most applications and can be bolted directly to a support surface. This variant is compliant with Japanese standards.
- Accommodate heavy loads in different directions
- Strong
- High degree of stiffness
- Narrow design
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
| Brand | Bando |
| Model | 400-DS8M-3720 |
| Brand | Consolidated Bearings |
| Model | HM-56 T |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF