We never sell your data to third parties
SKF SY 7/8 FM 2-bolt cast-iron pillow block bearing unit for 7/8 in shaft with set screw locking. The pre-lubricated insert bearing is sealed for maintenance-free operation. Designed for conveyor head shafts, fan supports, and general industrial drives.
MODEL SY 7/8 FM
$34.73 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable:No
Bearing Bore Type
Cylindrical
Bearing Sealing
Seal on both sides
Dimension Type
Inch
Fastening Bolt Hole Type (Housing)
Plain holes
Housing Material
Cast iron
I.D.
7/8 in
Inner Diameter (mm)
22.225
Lubricant (in Bearing)
Grease
O.D. (in)
5 1/9
Outer Diameter (mm)
130.000
Relubrication Nipple
With
Unit Sealing
Without
Width (mm)
41.500
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
#130867
Brand
Dodge
Model
P2B-SXV-014
#274725
Brand
NTN Bearing
Model
JELP-7/8
| Brand | Toshiba |
| Model | 0052DPSA31A-P |
| Brand | Teco-Westinghouse |
| Model | GHV1/54C |
| Brand | Teco-Westinghouse |
| Model | NPV0502C |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF