We never sell your data to third parties
SKF WSTU 100M-SRB-CRE is a take-up bearing unit for 100mm shaft applications. The unit includes a spherical roller bearing insert in a cast-iron housing with a corrosion-resistant coating. Designed for conveyor systems and tensioning applications requiring self-alignment and high load capacity.
MODEL WSTU 100M-SRB-CRE
$1,280.77 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Basic Dynamic Load Rating
433.02 kN
Basic Static Load Rating
490.02 kN
Bearing Housing Seal Type
Radial lip seal
Bearing Insert
Spherical roller bearing
Bearing Material
Bearing steel
Bearing Position
Non-locating
Bore Type
Cylindrical
Coating
Without
Grease Fitting
With
Housing
Cast iron
Housing Overall Width
101.6 mm
Housing Type
Take-up, wide slot
Inner Ring Retaining Feature
SKF ConCentra
Limiting Speed
2000 r/min
Lubricant
Grease
Pack Height
330 mm
Pack Length
330 mm
Pack Width
130 mm
Relubrication Hole
With
Shaft Diameter
99.9998 mm
Total Bearing Width
88.4682 mm
Unit Sealing
Without
Roller bearing unit
Pillow (plummer) block roller bearing units and take-up roller bearing units consist of a spherical or tapered roller bearing mounted in a non-split housing that can be bolted to a support surface. The units are sealed and lubricated and ready to use. This assortment of units covers a wide range of requirements, in metric and inch dimensions.
- Ready to mount
- Factory lubricated and sealed
- Quick locking on the shaft
- Long service life
- Easy to replace
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF