We never sell your data to third parties
Image for Illustration purposes only. Actual product may vary
SKF P2B 108-SRB-SRH is a 1-1/2 inch shaft 2-bolt pillow block bearing unit with set screw locking. The cast-iron housing supports a pre-lubricated insert bearing for conveyor head shafts, fan supports, and general industrial drives.
MODEL P2B 108-SRB-SRH
$264.85 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable:No
Attachment Bolt Diameter
12.7 mm
Basic Dynamic Load Rating
82.8 kN
Basic Static Load Rating
91.5 kN
Bearing Housing Seal Type
Radial lip seal
Bearing Insert
Spherical roller bearing
Bearing Material
Bearing steel
Bearing Position
Locating
Bore Type
Cylindrical
Centre Distance Between Bolt Holes
129.38125 mm
Centre Height (pillow Block)
47.625 mm
Coating
Without
Grease Fitting
With
Housing
Cast iron
Housing Overall Width
53.975 mm
Housing Type
Pillow block
Inner Ring Retaining Feature
Set screws
Limiting Speed
5120 r/min
Lubricant
Grease
Number of Bolt Holes for Fasteners
2
Pack Height
205 mm
Pack Length
205 mm
Pack Width
85 mm
Relubrication Hole
With
Shaft Diameter
38.1 mm
Total Bearing Width
69.85 mm
Unit Sealing
Optional end cover
Pillow block roller bearing unit, two-bolt, set screw locking
Pillow (plummer) block roller bearing units and take-up roller bearing units consist of a spherical or tapered roller bearing mounted in a non-split housing that can be bolted to a support surface. This variant has a spherical roller bearing, a two-bolt base and set screw locking, holding the shaft firmly against the inner ring of the bearing. The units are sealed and lubricated and ready to use. This bearing unit covers a wide range of requirements, in inch dimensions.
- Ready to mount
- Robust
- Factory lubricated and sealed
- Quick mounting
- Long service life
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
#507369
Brand
Rexnord
Model
10415927
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF