We never sell your data to third parties
Image for Illustration purposes only. Actual product may vary
Consolidated Bearings 6206-2RS deep groove ball bearing features a 30mm bore, 62mm OD, and 16mm width. Double sealed with rubber seals on both sides for protection against contaminants. Suitable for high-speed applications requiring low friction and quiet operation.
MODEL 6206-2RS
$23.09 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: Yes
I.d.
30 mm
O.d.
62 mm
Width
16 mm
This part is a Consolidated Bearings 6206-2RS DEEP GROOVE BALL BEARING SEALED It can be considered an interchange for the following models: Fafnir 206PP, FAG 6206.2RSR, Federal 1206RR, MRC 206-SZZ, New Departure Z99506, Norma Hoffman 206KK, RIV ALN 30, SKF 6206-2RS1, Steyr 6206.2RS.
More information about the product:
- Some inch bore sizes (SKF, Fafnir, MRC, ND) bearings are shielded.
How do I choose the right type of bearing for my application?
Start with the load and how it’s applied. You need to know if you’re dealing with radial loads, axial loads, or a mix of both. Then look at speed, operating environment, and space constraints. For example, ball bearings are great for high speed and lighter loads, while roller bearings handle heavier loads but usually at lower speeds. If there’s contamination, moisture, or heat involved, you may need sealed bearings or specific materials. In most cases, the right choice comes down to matching load type, speed, and environment to the bearing design.
What is the difference between deep groove and angular contact ball bearings?
Deep groove ball bearings are the most common type. They’re designed to handle mainly radial loads, but they can also take some axial load in both directions. They’re simple, versatile, and used in everything from motors to conveyors. Angular contact ball bearings are built for combined loads, especially where there’s significant axial force in one direction. They’re often used in pairs and are common in higher precision or higher load applications like pumps and gearboxes. If your load is mostly radial, go deep groove. If axial load matters more, angular contact is usually the better choice.
After greasing, the bearing is ready to be reinstalled. If you are not immediately installing the bearing, make sure it is properly protected in a waterproof wrapper and stored in a safe location.
Read More
| Brand | Coilhose |
| Model | N38-17B |
| Brand | Jason Industrial |
| Model | 1440-8M-75 |
| Brand | Consolidated Bearings |
| Model | FY-215 |
| Brand | Consolidated Bearings |
| Model | NJ-211E C/3 |
| Brand | Martin Sprocket |
| Model | 1 B 40 TB |
