Dixon WB1C King Cable® hose-to-hose service fitting with safety clip and lanyard for Air King couplings. Accommodates 1/2" to 1-1/4" (13mm to 32mm) hose ID. Constructed from galvanized carbon steel for corrosion resistance. Length is 20-1/4". The safety clip and lanyard provide secure connection and easy disconnection in air service applications.

Applications

When hose, couplings or clamps fail, or there is an accidental separation of the assembly, King safety cables minimize damage to equipment and injuries to operators.

Construction

Features

• King cable is the low cost answer to eliminate injuries caused by broken air hose connections
• King safety cable reaches across the hose fittings to provide standby safety for hose. Spring-loaded loops in the cable ends open easily to pass over the couplings for a firm grip on the hose.
• Thoroughly tested with years of service. A positive safeguard for air hose connections - helps you meet today's safety standards.
• Highly resistant to rust and corrosion

Installation

• Must be installed in the extended position (no slack)
• No tools needed - easy to install and remove

Note

Cables are shipped with safety restraint labels attached

Safety Notes

• King Safety cable must be installed in the extended position (no slack)
• The Canada Occupational Safety and Health regulations Part XIII, 13:6b states: "Where an air hose is connected to a portable air powered tool used by an employee, a restraining device shall be attached to all hose connections, in order to prevent injury to an employee in the even of an accidental disconnection of a hose."

Use

WB1 with safety clip and lanyard used to lock Air King couplings