We never sell your data to third parties
SKF / CR Seals (formerly CR Seals) 16500 is a small bore radial shaft oil seal designed for light-duty applications. This seal features a nitrile rubber (NBR) sealing lip with spring loading for reliable radial contact. Operating temperature range: -40°F to 250°F. Suitable for use in electric motors, gearboxes, pumps, and other rotating equipment. Prevents lubricant leakage and contaminant ingress.
MODEL 16500
Contact supplier for technical support on: 267-436-6000
$23.87 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Auxiliary lip
Yes
Design
CRWA1
Housing bore diameter
67.462 mm, 2.656 in
Maximum operating temperature
150.0 °C, 302.0 °F
Maximum operating temperature (°F)
150.0 °C, 302.0
Minimum operating temperature
-40.0 °C, -40.0 °F
Minimum operating temperature (°F)
-40.0 °C, -40.0
Permissible circumferential speed
13.15 m/s
Rotational speed
6000.0 r/min
Seal width
7.95 mm, 0.313 in
Sealing lip material
Polyacrylate elastomer (ACM)
Shaft diameter
41.783 mm, 1.645 in
Type of outside diameter
Metal-cased with sealant coating on the outside diameter
Unit system
Inch
Radial shaft seal with metal case, SKF Wave lip and auxiliary, contacting lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRWA1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, a garter spring to optimize sealing against the shaft, and a dust lip to improve contamination exclusion. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Brand | NoTrax |
| Model | 977S0035CY |
| Brand | Guardair |
| Model | N886 |
| Brand | Crown |
| Model | WC RPLPAD |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF