We never sell your data to third parties
SKF / CR Seals 404553 VR1 V-Ring axial face seal for rotating shafts. Provides reliable contaminant exclusion and lubricant retention. Flexible elastomer lip accommodates axial movement and misalignment. Suitable for electric motors, gearboxes, pumps, and industrial rotating equipment.
MODEL 404553
Contact supplier for technical support on: 267-436-6000
$468.36 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR4
Max shaft diameter
460.0 mm, 18.11 in
Min shaft diameter
455.0 mm, 17.913 in
Seal width
65.0 mm, 2.559 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter, maximum
460.0 mm, 18.11 in
Shaft diameter, minimum
455.0 mm, 17.913 in
V-ring seal, VR4 design, North American standard, interchangeable with VE design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR4 design has the largest cross section of the V-ring designs and permits the largest axial displacements. VR4 seals are commonly used as secondary seals for heavy-duty applications where the primary seal has to be protected against water and solid contaminants.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
- If not in stock alternatives can be produced by SKF SEAL JET systems
| Brand | Greenfield Threading |
| Model | 411900 |
| Brand | PHOENIX CONTACT |
| Model | 2902853 |
| Brand | Greenfield Threading |
| Model | 330071 |
| Brand | Vikan |
| Model | 44015 |
| Brand | Cutler Hammer |
| Model | XTCE115G00A |
| Brand | Vikan |
| Model | 77645 |
| Brand | Vikan |
| Model | 56891 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF