We never sell your data to third parties
SKF / CR Seals 6909 radial shaft oil seal for 0.750" shaft diameter, 1.002" housing bore, and 0.250" seal width. Features an NBR sealing lip with spring loading for reliable radial contact. Operating temperature: -40°F to 250°F. Used in motors, gearboxes, pumps, and industrial rotating equipment. Prevents lubricant leakage and contaminant ingress.
MODEL 6909
Contact supplier for technical support on: 267-436-6000
$20.41 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Auxiliary lip
No
Design
CRW1
Housing bore diameter
31.75 mm, 1.25 in
Maximum operating temperature
200.0 °C, 392.0 °F
Maximum operating temperature (°F)
200.0 °C, 392.0
Minimum operating temperature
-40.0 °C, -40.0 °F
Minimum operating temperature (°F)
-40.0 °C, -40.0
Permissible circumferential speed
12.35 m/s
Rotational speed
14834.0 r/min
Seal width
6.35 mm, 0.25 in
Sealing lip material
Fluoro rubber (FKM)
Shaft diameter
15.88 mm, 0.625 in
Type of outside diameter
Metal-cased with sealant coating on the outside diameter
Unit system
Inch
Radial shaft seal with metal case and SKF Wave lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Brand | Bestorq |
| Model | 11/C390 |
| Brand | Hanson |
| Model | 70081 |
| Brand | Silverthin |
| Model | STE-730 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF