We never sell your data to third parties
SKF / CR Seals (formerly CR Seals) 30X47X8 HMS5 V is a HMS5 Single Lip radial shaft seal (lip seal) designed for 30mm shaft diameter, 47mm housing bore, and 8mm seal width. Constructed with a NBR sealing lip and spring-loaded garter spring for consistent radial sealing force. Operating temperature range: -40°F to 250°F (-40°C to 121°C). Suitable for use in electric motors, gearboxes, pumps, and other rotating equipment.
MODEL 30X47X8 HMS5 V
Contact supplier for technical support on: 267-436-6000
$19.67 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable: See conditions
Auxiliary lip
No
Design
HMS5
Housing bore diameter
47.0 mm, 1.85 in
Maximum operating temperature
200.0 °C, 392.0 °F
Maximum operating temperature (°F)
200.0 °C, 392.0
Minimum operating temperature
-20.0 °C, -4.0 °F
Minimum operating temperature (°F)
-20.0 °C, -4.0
Permissible circumferential speed
19.47 m/s
Rotational speed
12420.0 r/min
Seal width
8.0 mm, 0.315 in
Sealing lip material
Fluoro rubber (FKM)
Shaft diameter
30.0 mm, 1.181 in
Type of outside diameter
Rubber metal reinforced
Unit system
Metric
Radial shaft seal with rubber outside diameter and single sealing lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. HMS5 seals are designed with a rubber outside diameter. They have a conventional sealing lip made of elastomer with a garter spring to maintain the right radial load.
- High pumping rate
- With garter spring
- Accommodate misalignment
| Brand | MROSupply Fasteners |
| Model | FSTPCK-105700 |
| Brand | Hammond Power Solutions |
| Model | MG3A0030SKSCGC0 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF