We never sell your data to third parties
Image for Illustration purposes only. Actual product may vary
SKF / CR Seals (formerly CR Seals) 24370 is a small bore radial shaft oil seal designed for light-duty sealing applications. Constructed with a nitrile rubber (NBR) sealing lip and spring-loaded garter spring for consistent radial force. Operating temperature range: -40°F to 250°F. Suitable for use in electric motors, gearboxes, pumps, and other rotating equipment. Prevents lubricant leakage and contaminant ingress.
MODEL 24370
Contact supplier for technical support on: 267-436-6000
$18.22 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Auxiliary lip
No
Design
CRWH1
Housing bore diameter
88.9 mm, 3.5 in
Maximum operating temperature
100.0 °C, 212.0 °F
Maximum operating temperature (°F)
100.0 °C, 212.0
Minimum operating temperature
-40.0 °C, -40.0 °F
Minimum operating temperature (°F)
-40.0 °C, -40.0
Permissible circumferential speed
8.7 m/s
Rotational speed
2700.0 r/min
Seal width
11.13 mm, 0.438 in
Sealing lip material
Nitrile rubber (NBR)
Shaft diameter
61.925 mm, 2.438 in
Type of outside diameter
Metal-cased with sealant coating on the outside diameter
Unit system
Inch
Radial shaft seal with double metal case, SKF Wave lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRWH1 seals are designed with a double metal case, an SKF WAVE lip made of elastomer with a higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
- For oil or grease
- With garter spring
- WAVE lip creates higher pumping rate
- WAVE lip has less friction between shaft and lip
- WAVE lip has a lower temperature at the contact point
| Brand | Linn Gear |
| Model | EX2.500 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF