We never sell your data to third parties
SKF / CR Seals 402204 VR1 V-Ring axial face seal for rotating shafts. Provides reliable sealing against contaminants and lubricant leakage in electric motors, gearboxes, and pumps. Flexible elastomer lip accommodates shaft misalignment and axial movement. Suitable for industrial rotating machinery.
MODEL 402204
Contact supplier for technical support on: 267-436-6000
$354.50 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 3 days
Returnable:No
Design
VR1
Max shaft diameter
235.0 mm, 9.252 in
Min shaft diameter
210.0 mm, 8.268 in
Seal width
25.0 mm, 0.984 in
Sealing lip material
Fluoro rubber (FKM)
Shaft diameter, maximum
235.0 mm, 9.252 in
Shaft diameter, minimum
210.0 mm, 8.268 in
V-ring seal, VR1 design, North American standard, interchangeable with VA design
V-ring seals (V-rings) are all-rubber, axial shaft seals. They offer an easy-to-install solution for rotating shaft applications, including use as a secondary seal in highly contaminated environments. The VR1 design includes a standard cross section with a straight back side face. Being the most common type of V-rings, VR1 seals are typically used to protect bearing arrangements in gearboxes, electric motors and drives.
- Easy to install
- Cost-effective
- Reliable contamination exclusion
| Brand | Cutting Tool Technologies |
| Model | SPEH-222P TIN |
| Brand | Cutting Tool Technologies |
| Model | SNMC-222B TIN |
| Brand | Fibox |
| Model | ULPC MH 125 G |
| Brand | Dormer Pramet |
| Model | 5985782 |
Disclaimer: The return policy information shown below is merely an excerpt from SKF's General Conditions of Sale.
RETURN OF GOODS FOR CREDIT
Goods will not be accepted for return without prior written approval from SKF. The return freight must be prepaid by the Buyer. Unless return of Goods is due to Supplier error, Goods returned will be subject to a credit service fee of $25.00 or 15% of the credit value, whichever is greater. An additional service fee may apply is further inspection is required at the discretion of SKF