We never sell your data to third parties
Leeson M1125006.00 0.06 HP, 300 RPM DC gearmotor with 30 NEMA frame and Totally Enclosed Non-Ventilated (TENV) enclosure. Operates on 90V DC at 60 Hz. Permanent magnet DC gearmotor designed for SCR drive control applications. Class F insulation, ball bearings.
MODEL M1125006.00
$544.00 Each
Prices are subject to change
FREE SHIPPING ON ORDERS OVER $100
Select Quantity
Typically Ships in: 1 day
Returnable:No
Current
0.8
Drive End Bearing Size
6000
Drive End Bearing Type
Ball
Duty
Continuous
Efficiency
57.6
Enclosure
TENV
Frame
30
Frame Length
2.99
Height
6.69
HP
0.06
Insulation Class
F
KW
0.04
Length
16.5
Opp. Drive End Bearing Size
6000
Opp. Drive End Bearing Type
Ball
RPM
300
Service factor
1
Shaft Diameter
0.500
Shaft Length
1
Shaft type
Parallel
Thermal protection
No Protection
UL
Recognized
Voltage
90
Width
7.68
Model PZ gearmotors
have the same mounting dimensions as Bodine model D and Z, Baldor/Boehm, Bison 100 gearmotors, and a number of Dayton gearmotors.
Mechanical Specifications
Precision machined in-line steel gears, with a first stage steel helical gear followed by spur-type gears. Lubrication is permanent semi-fluid grease, reducing possibility of leakage. Output shafts have needle bearings for high load capacities. Shafts are hardened steel. Conduit Box not included with motor.
Application Notes
These gearmotors are designed for mounting at any angle, but motor below the reducer should be avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail. The motor’s stall torque could exceed recommended full load torques. If this service is anticipated, a current limiting device should be used. This issue is even more critical for low voltage motors, typically no controller is used since motor connected directly to battery, so some type of current limit or fusing should be considered. Overhung load capacities shown are at the center of output shaft.
| RPM: 300 | Volts | 90 | Volts | |
|---|---|---|---|---|
| HPKW: 1/17 | F. L. Amps | 0.8 | F. L. Amps | |
| Frame: 30 | S. F Amps | S. F Amps | ||
| Max Amb: 40 | Hertz | Phase | ||
| Insul Class: F3 | Duty | CONT | TYPE | DN |
| Model #: 985.630 | Serv. Factor | 1.0 | PF | |
| Eff 100%: | Eff 75% | Enclosure | TENV | |
| Protection: NOT | Therm. Prot. | Bearing OPE | ||
| Design: | Code | Bearing PE | ||
| UL: Yes | CSA | Yes | CE | Yes |
| Torque lb-In: 10 | Nameplate | M100414702 | Lubrication | |
| Series: PZ | Overhung Ld. | 180 | Shaft Type | PARALLEL |
SKU: 2525294
Couldn’t be happier
This motor was a very good price and I received it within 2 days. I couldn’t be happier.
Read moreSKU: 2525011
Product fine shipping not so much
The Leeson motor was fine and worked as it should. The shipping however had alot to be desired. I know the product was coming from the Allentown warehouse which is about a 35 min drive but still took 4 days to get here and when it arrived the box was trashed. I know this is not your fault and is more of a FedEx issue but something to be aware of.
Read moreSKU: 2525000
Leeson 1/2hp 56j frame 1ph motor
Great Price, Good brand we have used many times. Price was really good and made it here ok thankfully. Would give 5 Stars but motor was loose in box when it got here and there was a hole almost punched through to the outside form shaft so some extra padding inside would have been cool, But it was free shipping so I can't complain that much. Would and will use again. Great Service!
Read more
| Brand | Rollway |
| Model | 6212 2RS C3 EMQ |
SKU: 2525294
Couldn’t be happier
This motor was a very good price and I received it within 2 days. I couldn’t be happier.
Read moreSKU: 2525011
Product fine shipping not so much
The Leeson motor was fine and worked as it should. The shipping however had alot to be desired. I know the product was coming from the Allentown warehouse which is about a 35 min drive but still took 4 days to get here and when it arrived the box was trashed. I know this is not your fault and is more of a FedEx issue but something to be aware of.
Read moreSKU: 2525000
Leeson 1/2hp 56j frame 1ph motor
Great Price, Good brand we have used many times. Price was really good and made it here ok thankfully. Would give 5 Stars but motor was loose in box when it got here and there was a hole almost punched through to the outside form shaft so some extra padding inside would have been cool, But it was free shipping so I can't complain that much. Would and will use again. Great Service!
Read moreItem must be unused.
Item must be in it's original package.
Restocking, shipping and handling fees may apply to any return with this manufacturer.
For more information please consult https://www.mrosupply.com/page/returnwarranty-policy/